Charge the PowerFlight Cell

Charge the PowerFlight Cell

1. Connect the charger’ s integrated line to the battery integrated port.

2. The charger power indicator shows a steady blue light indicating standby mode; then short press the linking switch on the smart battery, and the indicator will change from a steady blue light to a flashing blue light, waiting for communication; then the flashing blue light turns to flashing green, indicating that it enters the charging mode.

 

Powerflight Cell

  1. Do not disassemble or modify the PowerFlight Cell for other purposes. Otherwise, the warranty will be invalid.
  2. Do not disassemble, puncture, impact, or drop the PowerFlight Cell.
  3. Do not operate the PowerFlight Cell with wet hands.
  4. Do not install or remove the PowerFlight Cell in water.
  5. Do not discard the PowerFlight Cell randomly.
  6. Do not expose the PowerFlight Cell to direct sunlight, fire, or place it in an environment where the temperature exceeds 60° C (140° F).
  7. Use the standard charger for charging.
  8. Place the PowerFlight Cell in a safe place and avoid contact with young children or animals.
  9. Check whether the PowerFlight Cell is normal before use. Using abnormal batteries may cause damage, electric shock, fire, and even life-threatening situations.
  10. If you need to store the PowerFlight Cell for more than one month, maintain the battery level at 40-60%.
  11. The transportation of the PowerFlight Cell needs to comply with relevant local laws and regulations.

 Restrictions & Local Regulations

It is prohibited to use this product in waters where there are swimmers or divers. It is forbidden to operate in restricted traffic areas. Make sure to strictly abide by local laws and regulations.

After Use 

  1. After use, press and hold the Power Button of the Jet ONE Controller for 5 seconds, and power off the Jet ONE Controller.
  2. Take the board out of the water. Short press the Power Button of the PowerFlight Cell and then long press for 2 seconds. The PowerFlight Cell will beep to confirm it is powered off. Unscrew the Rotary Locks and remove the PowerFlight Cell.
  3. Unscrew the Main Wing and Tail Wing Fixing Bolts and remove the wings.
  4. Unscrew the L-shaped Fixing Bolts to uninstall the Power Assembly.
  5. Rinse off the sand and dirt from the Board and other parts with fresh water.
Back to blog